Celestron Travel Scope 70 Quick Setup Manual - Page 3
Browse online or download pdf Quick Setup Manual for Telescope Celestron Travel Scope 70. Celestron Travel Scope 70 8 pages. Up to 40x magnification full-height tripod with altazimuth mount
Also for Celestron Travel Scope 70: Instruction Manual (12 pages)
Print Page
10
Insert the barrel of the 20mm eyepiece into the
diagonal and tighten the setscrew.
13
Remove the lens cap from the front of the telescope.
To observe, look through the eyepiece as shown.
Focus the image by turning the knobs below the
focuser.
11
Remove the knurled nuts on the threaded posts at
the focuser end of the telescope tube.
14
To move the scope right and left, hold a tripod leg
with one hand while the other hand uses the panning
handle to move the scope. You can loosen or tighten
the azimuth locking screw to adjust the tension.
12
Locate the finderscope and remove the plastic caps
on the front and back lens. Orient the finderscope so
that the larger lens is facing towards the front of the
tube as shown. Place the finderscope over the posts
on the tube and replace the knurled nuts to secure
it in place.
15
To move the scope up and down, rotate the entire
pan handle counterclockwise and use the handle to
point the scope in the direction you want to view.
Rotate the pan handle clockwise to lock it in place.
For more information on this product or to
download the instruction manual, please visit the
respective product page on celestron.com
SOLAR WARNING: Never attempt to view
the Sun through any telescope without a proper
solar filter.
NEED ASSISTANCE?
Contact Celestron Technical Support
celestron.com/pages/technical-support
08-22
2