ADEMCO 5819 Installation Instructions And Operators Manual - Page 2
Browse online or download pdf Installation Instructions And Operators Manual for Transmitter ADEMCO 5819. ADEMCO 5819 2 pages. Shock processor transmitter
Print Page
Wiring Connections
With the battery still not inserted, connect the shock
processor loop (if used) to the unit's loop TB1 terminals
(see Detail "B"). The contact loops must use closed
circuit devices. TB2 can be used for normally closed
contacts.
Note: If the contact loops are not used, no connection
is needed across their terminals.
"Enrolling" the Transmitter Serial Number
Each No. 5819 Shock Processor has its own unique
serial
number
permanently
manufacture. Each input
distinct "loop" number that must be input to the QED
control panel during installation. Assign each to an
individual zone and designate the Input Type as "RF"
(Supervised RF).
The serial number can be input by one of the following
methods:
1. "Enrolled" by transmitting from the device during
zone programming (pressing the tamper switch,
shorting any loop, etc.).
2. Entered through the keypad at the "Input S / N "
"Transmit Now" prompt during manual zone
programming.
3. Entered through VLINK Downloading Software and
downloaded to the QED control.
When programming the 5819 transmitter's serial
number at the QED control panel, do the following:
•
At the "Input Type" prompt, enter "3" for RF
(Supervised RF).
•
When prompted for the loop number, enter the
input loop you are using (see Diagram 2). See the
QED control panel's installation instructions for
specific programming procedures.
àN7491V3jä
N7491V3 5/98
assigned
during
the transmitter also has a
of
1 6 5 E i l e e n W a y , S y o s s e t , N e w Y o r k 1 1 7 9 1
C o p y r i g h t © 1 9 9 6 P i t t w a y C o r p o r a t i o n
•
BATTERY INSTALLATION/REPLACEMENT
1.
Remove the transmitter's cover as described in
Mounting Step 1.
2.
Observe correct polarity and insert the battery
provided into the battery holder (see Diagram 2).
3.
Replace the cover, engage the hooks along one
edge and snap shut.
Do not bend the antenna.
Note: Replace with 3V Lithium battery only:
Panasonic CR123A, Duracell DL123A, Sanyo
CR123A, ADEMCO 466, or Varta CR123A
BATTERY CAUTION: Risk of fire, explosion and burns.
Do not recharge, disassemble, heat above 212° F (100°
C) or incinerate. Dispose of used batteries promptly.
Keep away from children.
UNIT DIMENSIONS
4.8" H x 1.5" W x 1" D
o r
Regular maintenance and inspection (at least annually
by the installer and frequent testing by the user are vital
to continuous satisfactory operation of any alarm
system. The installer should assume the responsibility
of developing and offering a regular maintenance
program to the user, as well as acquainting the user
with the proper operation and limitations of the alarm
system and its component parts. Recommendations
must be included for a specific program of frequent
testing (at least weekly) to insure the system's operation
at all times.
REFER TO THE INSTALLATION INSTRUCTIONS FOR
THE QED RECEIVER/CONTROL WITH WHICH THIS
DEVICE IS USED FOR WARRANTY INFORMATION,
AND FOR DETAILS REGARDING THE LIMITATIONS
OF THE ENTIRE ALARM SYSTEM.
TO THE INSTALLER