ADEMCO VISTA-50PUL Installation Supplement Manual - Page 4

Browse online or download pdf Installation Supplement Manual for Control Panel ADEMCO VISTA-50PUL. ADEMCO VISTA-50PUL 16 pages. E2 zone programming

Print Page

XMIT TO CONFIRM

PRESS

TO SKIP

Entd A022-4063 2

Rcvd A022-4064 2

To Delete a Serial No

Zn ZT P RC In L

10 03 1 10 RF 1s

ENTER ZONE No.

(00 = QUIT)

)ROORZLQJ WKH VXFFHVVIXO HQUROOPHQW RI HDFK ZLUHOHVV GHYLFH UHPRYH 21( RI WKH VHULDO

QXPEHU ODEHOV IURP WKH GHYLFH DQG DIIL[ LW LQ WKH DSSURSULDWH FROXPQ RQ WKH ZRUNVKHHWV

SURYLGHG ZRUNVKHHWV VWDUW RQ SDJH WKHQ HQWHU WKH RWKHU LQIRUPDWLRQ ]RQH QXPEHU ORRS

QXPEHU ]RQH W\SH HWF UHOHYDQW WR WKDW GHYLFH

When you have finished programming all zones, test each using the system's Test mode. Do not use the

Transmitter ID Sniffer Mode for this, as it will only check for transmission of one zone on a particular

transmitter. It will NOT check the zones assigned to each additional loop, and will not verify polling loop

type zones.

9. Confirmation Option: This prompt will only appear if you answered

"Yes" in step 1.

The system will enter a confirmation mode so that the operation of the

actual programmed input can be confirmed. Activate the loop input or

button that corresponds to this zone.

If the serial number/loop number combination transmitted does

not match the serial number entered, a display similar to the one at the

left will appear.

If so, activate the loop input or button on the transmitter once again. If

a match is not obtained (i.e., summary display does not appear), press

the [#] key twice and then enter or transmit the correct serial number

again.

To delete an existing serial number, enter "0" in the loop number field.

The serial number will change to "0"s.

10 INPUT S/N:

If "0" was entered in error, simply re-enter the loop number or press [#],

and the serial number will return to the display. Otherwise, press [ ] to

accept.

If the serial number transmitted does match the serial number

entered, the keypad will beep 3 times and a summary display will

appear, showing that zone's programming. Note that an "s" indicates

that a transmitter's serial number has been enrolled.

Press [ ] to accept the zone information.

10. The system will return you to the "ENTER ZN No." prompt for the next

zone.

When all zones have been programmed, enter "00" to quit.

A 0 0 0 - 0 0 0