GALA mitta Installation Manual - Page 7

Browse online or download pdf Installation Manual for Bathroom Fixtures GALA mitta. GALA mitta 12 pages. Hydromassage bathtubs
Also for GALA mitta: User Manual (16 pages), Installation Manual (12 pages), User Manual (16 pages), Installation Instructions Manual (12 pages)

Print Page

2- WITH

PANEL

Installation with Panel is described in the INSTALLATION INSTRUCTIONS, which are enclosed with the

bath.

This system avoids the need to provide an access hatch and ventilation grille. Access to the

hydromassage bath equipment for maintenance purposes is achieved by removing the skirting, and

ventilation is provided through the gap between the skirting and the floor. Under no circumstances should

this gap be sealed.

1. The plumbing installation must comply with the corresponding regulations applicable in each

country.

2. For the installation of taps, please consult the INSTALLATION INSTRUCTIONS corresponding to

each bath, which advise on how best to position them.

3 .The automatic plug must be connected to the effluxion system by means of an elastic joint.

The electrical installation must comply with low voltage regulations and with the corresponding

regulations of each country.

1. Installation

Electrical connections must provide a minimum of Ipx5

rotection within volume 1. A connecting box (in accordance

with the protection established) is recommended. Care must

also be taken to make this connection at a height of more

than 20 mm above the floor.

No switches, power sockets or light fittings shall be installed

in volumes 0 and 1. Above these volumes it shall be

permissible to have sound control contactors operated by a

draw-cord or chain of non-hygroscopic material.

Switches shall not be installed in volume 2, however safety

power sockets can be installed. Fixed light fittings may also

be installed, preferably with category II insulation or, if

unavailable, install those which do not have any accessible

metallic part. In the lamp holders it shall not be possible to

make any accidental contact with live parts when inserting or

removing bulbs. In such light fittings no switches or power

sockets are allowed, except if these are safety power

sockets.

2. Wiring

The power cable used must be the one supplied with the bath or another of similar characteristics (with

the cover having characteristics not inferior to type H05 V V-F), taking into account the maximum voltage

stipulated in the low voltage regulations. The section of cable supplied is 1,5 mm .

Installation manual

PLUMBING INSTALLATION

Volumen 0

Volume 0

Volume 1

Fig-3