Hidrotermal HIDRO-SPR200(H) User Manual - Page 4

Browse online or download pdf User Manual for Swimming Pool Pump Hidrotermal HIDRO-SPR200(H). Hidrotermal HIDRO-SPR200(H) 6 pages.

Print Page

5.Controls Prior to Initial Start-up

Verify that the pump shaft turns freely.

Check that the mains voltage and frequency are according to the name plate.

The hydromassage assembly should be equipped with a system to prevent the pump

from starting up if a minimum water level is not present.

Check the rotating direction of the motor, which should concur with that indicated on

the fan cover.

If the motor does not start up, try to locate the problem in the table of most common

faults and their possible solutions that is provided further on.

THE PUMP SHOULD NEVER OPERATE DRY.

6.Start-up

Start electrically the pump only when the suction and discharge pipes are connected

to the corresponding inlets and outlets. Check that there is no obstacle in the pipes.

Apply voltage to the motor and suitably adjust the jets to obtain the dwsired flow.

7.Maintenance and clean

Our pumps for hydromassage facilities do not require any special maintenance or

programming.

If the pump will be idle for a long period of time, it is recommended to disassemble,

clean and store it in a dry, well-ventilated place. If the supply cord is damaged, it must

be replaced by the manufacturer or its service agent or a similarly qualified person to

a hazard.

Pump can be automotive empty water after correct installation.

When the pump needs to clean (1) filling with water up to level position of bathtub's

nozzle, (2) operating 2-3mimute,(3) exhausting water of bathtub after engine stop.

8.Trouble Shooting Guide

SYMPTOM

PUMP DOES

NO TURN

PUMP NOT

PUMPING

PROPERLY

POSSIBLE CAUSE

NO POWER

TO PUMP

BLOCKAGE OR

LEAK

LOW VOLTAGE

※Incoming power to the pump?

※Is circuit breaker on?

※Is GFCI operating properly?

※Is the air switch plugged in?

※Jets should be pointed away from the

suction inlet so air is not forced into pump

suction.

※Is the in-tub suction inlet blocked or

covered?

※Is there any debris in the pump housing?

※Is there a leak in the piping or the pump?

※Is the proper voltage applied to the pump?

※Is there an extension cord being used?

CHECK