ADEMCO TeleCommand User Manual - Page 8

Browse online or download pdf User Manual for Control Unit ADEMCO TeleCommand. ADEMCO TeleCommand 20 pages. Telephone module

Print Page

Executing Security System Commands

After accessing the security system, and at any point during, or

immediately after TeleCommand reports system status, it is possible

to execute most security system commands using the keys on the

telephone. For ADEMCO security systems, you would use the same

key entries normally performed at the system keypad; typically your

4-digit system code followed by a command key.

OMNI and IntelliSense security systems, the special key functions

(STAY, BYPASS, and INSTANT) are enabled by pressing the

appropriate key combination on the telephone keypad and entering

your four-digit user code. The FBII/IntelliSense key combinations are

as follows:

Example: To arm an FBII/IntelliSense system to STAY INSTANT

mode, pressing [✱] + [1] + [✱] + [3] + [four digit user code]

Refer to the security system's User Guide for specific key entries

required (also see the TYPICAL SYSTEM COMMAND ENTRIES).

Command entries can be made during the pauses that occur between

each of the individual status reports, or during the pause immediately

following the complete report.

DO NOT PRESS ANY KEYS DURING VOICE MESSAGES.

If the status report annunciates "System Not Ready," a condition exists (such

as an open zone) which will make it impossible for you to arm the system unless

the open zone is made intact or bypassed during the arming procedure. If not

already announced, pressing the ✱ key during a pause in the status report will

cause TeleCommand to announce the particular zones that are faulted (which

door or window is open, for example).

Following your entry of a system command, wait for status

confirmation of the command from TeleCommand.

Pressing [✱] + [1] = STAY

Pressing [✱] + [2] = BYPASS

Pressing [✱] + [3] = INSTANT

For FBII