Automotive Data Solutions iDatastart TR2450AE Owner's Manual - Page 10
Browse online or download pdf Owner's Manual for Remote Starter Automotive Data Solutions iDatastart TR2450AE. Automotive Data Solutions iDatastart TR2450AE 16 pages.
Print Page
Once remote started from your factory key fob or long-range remote, your vehicle will run for the programmed
'runtime' setting. The default runtime is 15 minutes but it can also be programmed for 3, 5, 10, 25, 30 or 35
minutes. If you wish to change your remote start runtime setting, contact your iDatastart Authorized Dealer.
KEY TAKEOVER FOLLOWING REMOTE START
The 'key takeover' procedure ensures that your engine does not shut down upon entering the vehicle, during
the programmed remote start runtime. To prevent your vehicle from shutting down, complete the steps below
within the programmed delay time (45 seconds, 90 seconds, 3 minutes or 4 minutes):
For Standard Key Vehicles
1. Unlock and enter vehicle
2. Close doors
3. Insert key into ignition and turn ignition to ON position
4. Press foot brake
For Push-To-Start Vehicles
1. Unlock and enter vehicle with valid smartkey
2. Close doors
3. Press foot brake
NOTE: This feature may not be supported on some vehicles. If available, the programmed 'key takeover' delay
time will be communicated to you by your iDatastart Authorized Dealer at the time of installation.
WHEN SERVICING YOUR VEHICLE
To ensure safety during vehicle servicing, the remote starter must be placed in 'Valet Mode'. The 'Valet Mode'
will disable remote start functionality. To activate or deactivate the 'Valet Mode', follow the instructions below:
With Vehicle Key:
Cycle ignition OFF/ON 2x rapidly, then press brake 3x.
FUNCTION
Valet Mode ON
Valet Mode OFF
# OF PARKING LIGHT FLASHES
1
2
2022-01-21 © Automotive Data Solutions Inc. 10/15
TR2450AE