Automotive Data Solutions TR1150AR Owner's Manual - Page 9

Browse online or download pdf Owner's Manual for Remote Starter Automotive Data Solutions TR1150AR. Automotive Data Solutions TR1150AR 16 pages.

Print Page

ADJUSTING ENGINE RUNTIME SETTINGS

Once remote started from your factory key fob or long-range remote, your vehicle will run for the programmed

'runtime' setting. The default runtime is 15 minutes but it can also be programmed for 3, 5, 10, 25, 30 or 35

minutes. If you wish to change your remote start runtime setting, contact your iDatastart Authorized Dealer.

The 'key takeover' procedure ensures that your engine does not shut down upon entering the vehicle, during

the programmed remote start runtime. To prevent your vehicle from shutting down, complete the steps below

within the programmed delay time (45 seconds, 90 seconds, 3 minutes or 4 minutes):

For Standard Key Vehicles

1. Unlock and enter vehicle

2. Close doors

3. Insert key into ignition and turn ignition to ON position

4. Press foot brake

For Push-To-Start Vehicles

1. Unlock and enter vehicle with valid smartkey

2. Close doors

3. Press foot brake

NOTE: This feature may not be supported on some vehicles. If available, the programmed 'key takeover' delay

time will be communicated to you by your iDatastart Authorized Dealer at the time of installation.

WHEN SERVICING YOUR VEHICLE

To ensure safety during vehicle servicing, the remote starter must be placed in 'Valet Mode'. The 'Valet Mode'

will disable remote start functionality. To activate or deactivate the 'Valet Mode', follow the instructions below:

With Vehicle Key:

Cycle ignition OFF/ON 2x rapidly, then press brake 3x.

TR1150AR