ActiVHeat 9BHWSL3 Series User Manual - Page 2

Browse online or download pdf User Manual for Accessories ActiVHeat 9BHWSL3 Series. ActiVHeat 9BHWSL3 Series 7 pages. Heated sock liners

Print Page

Lower drain and lower capacity batteries will result in shorter heating

times and lower heat levels.Use of batteries that have been stored for a

long period or have already been used may result in the glove liners not

heating properly. You MUST NOT use 1.2V AA rechargeable NiMh or

NiCd batteries as they will be damaged by the battery packs. You

may use rechargeable Zn-Ni 1.6V 1500mAh AA batteries. Other re-

chargeable upgrade solutions are available from www.activheat.com.

Put on your sock liners with the sockets facing the INSIDE of your legs.

The wires inside the soft fabric channel running down the inside of the

socks do not produce any heat. These sock liners heat under the soles of

your feet.

Installing the Batteries

Unwrap the fabric Ankle Wraps and remove

the Battery Packs .

1. Gently slide open the Battery Compart-

ment Cover on a Battery Pack .

2. Insert three suitable AA batteries ensur-

ing the +ve and –ve terminals of the batteries

match the terminals for the battery compart-

ments as shown right. The middle battery should

inserted with the + sign towards the switch and

the two outer batteries should be inserted with

the + sign away from the switch .

3. Test whether the batteries are inserted correctly

by sliding the switch on the top of the battery

pack (shown opposite). If the heat level light illu-

minates RED or GREEN then the batteries are installed correctly. If it

does not illuminate then check the battery orientation is correct.

4. Slide the switch until the light goes off so you don't waste the batteries.

5. Gently slide the cover closed.

1. The Battery Pack has a plug at one end of the ca-

ble. This plug at the end of a curly Power cable con-

nects to a socket on your sock liner.

Firmly connect the plugs on the Battery Packs to the

sock liners sockets. If plugs and sockets are not

firmly connected, the sock liners will not heat