Aire Spring Haven 04612 Instruction Manual - Page 8
Browse online or download pdf Instruction Manual for Fan Aire Spring Haven 04612. Aire Spring Haven 04612 16 pages.
Print Page
ELECTRICAL CONNECTIONS
WARNING: To avoid possible electrical shock be sure electricity is turned off at the main fuse or breaker box before
wiring.
NOTE: This remote control unit is equipped with 16 code combinations to prevent possible interference from or to other
remote units. The frequency switches on your receiver and remote control have been preset at the factory. Please
recheck to make sure the switches on the remote control and the receiver are set to the same position (Fig. 11). Any
combination of settings will operate the fan as long as the switches in the remote control and receiver are set to the
same position.
Step 1. Insert Receiver into Hanger Bracket with the flat side of the Receiver facing the ceiling. (Fig. 12)
Step 2. Motor to Receiver Electrical Connections: Connect the WHITE wire from the fan to the WHITE wire marked "TO
MOTOR N" from the Receiver. Connect the BLACK wire from the fan to the BLACK wire marked "TO MOTOR L" from the
Receiver. Connect the BLUE wire from the fan to the BLUE wire marked "FOR LIGHT" from the Receiver. (Fig. 13)
NOTE: Fan must be installed from a maximum distance of 40 feet from the transmitting unit for proper signal
transmission between the transmitting unit and the fan's receiving unit.
Step 3. Receiver to House Supply Wires Electrical Connections: Connect the WHITE wire (Neutral) from the outlet box to
the WHITE wire marked "AC in N" from the receiver. Connect the BLACK wire (Hot) from the outlet box to the BLACK wire
marked "AC in L" from the receiver. Secure all wire connections with the plastic wire nuts provided. (Fig. 13)
Step 4. If your outlet box has a GROUND wire (Green or Bare Copper) connect this wire to the Hanger Ball and Hanger
Bracket Ground wires. If your outlet box does not have a Ground Wire, then connect the Hanger Ball and Hanger Bracket
Ground Wires together. Secure wire connection with the plastic wire nut provided. (Fig. 13)
After all splices are made, check to make sure there are no loose strands. As an additional precaution we suggest to
secure the plastic wire connectors to the wires with electrical tape.
FIG. 11
RECEIVER
HANGER
BRACKET
FIG. 12
8
OUTLET BOX
BLACK (HOT)
BLACK ("AC IN L")
RECEIVER
BLACK ("TO MOTOR L")
BLUE (FOR LIGHT)
FIG. 13
WHITE (NEUTRAL)
GREEN OR BARE
COPPER (GROUND)
WHITE ("AC IN N")
WHITE ("TO MOTOR N")
(CONNECT TO
GROUND-
GROUND WIRE ON
(GREEN)
HANGER BRACKE
IF NO HOUSE
GROUND WIRE
EXISTS.)
WHITE (NEUTRAL)