DYNAMICS GROUP Dings 8-63010-67B Instructions Manual - Page 12

Browse online or download pdf Instructions Manual for Industrial Equipment DYNAMICS GROUP Dings 8-63010-67B. DYNAMICS GROUP Dings 8-63010-67B 12 pages. Hazardous brake

Print Page

BRAKE DOES NOT RELEASE

BRAKE DOES NOT STOP

BRAKE CHATTERS OR HUMS

ORDERING INFORMATION

Please provide the following information to

expedite your renewal parts orders:

Model Number

Serial Number (if available)

Voltage, Phase and Frequency

Hub Bore and Keyway Dimensions

Horizontal or Vertical Mounting

(if vertical, specify whether above or below

motor)

4740 W. ELECTRIC AVE.

MILWAUKEE, WI 53219

TROUBLESHOOTING

Check for broken lead wire, low voltage, and

the power supply to brake.

Check for worn or broken friction discs.

Check brake hub to make certain it has not

shifted on shaft.

Check manual release. When brake coil is

energized, release knob should move freely

to reset position.

Check thermal release. Release may have been

activated.

Check magnet faces. They must be clean and

parallel.

Check shading coil (not illustrated) located in

slots on magnet center pole. Shading coil must

be in position and not broken.

414/672-7830

FAX 414/672-5354

www.dingsco.com

Printed in U.S.A. BK4614 (1/00)