Hifionics BRUTUS BRX2400.1D Installation Instructions Manual - Page 9

Browse online or download pdf Installation Instructions Manual for Amplifier Hifionics BRUTUS BRX2400.1D. Hifionics BRUTUS BRX2400.1D 13 pages. Brutus brx series amplifers

Print Page

BRX2000.1D MONO AMPLIFIER APPLICATIONS

Basic application

Interconnect cable checklist:

- Connect the line inputs to a Radio/CD RCA outputs or line output of the

full range primary amplifier with good quality RCA cables. A "Y" adapter

may be needed as shown in the diagram.

- Use at least 16 gauge speaker wiring. These amplifiers have dual

speaker terminals, simplifying the hookup of multiple speakers. The 2

positives are the same and the 2 negatives are the same.

Crossover frequency control checklist:

- LOW PASS: 35Hz to 250Hz

- SUBSONIC:15 Hz to 35 Hz

- BASS EQ: 0 to 10dB

- PHASE: 0 to 180 degrees

Level control checklist:

- Refer to the section "Setting up systems after installation for best

performance"

DESIGNATED

MONO LINE INPUT

B O O S T

H F R - 3

M I N

M A X X

Dual Subwoofer Application

DESIGNATED

MONO LINE INPUT

B O O S T

H F R -3 M INM A X X

BRUTUS

Minimum final loudspeaker impedance:

- 1 ohm.

FULL RANGE

STEREO LINE INPUT

NOT USED

Note: You can use the Radio/CD designated mono line output

or a full range stereo line output. For full range stereo line output,

you will need an optional "Y-Adaptor" as shown

Y-ADAPTOR

MONO

SUBWOOFER

1-OHM MINIMUM

REMOTE TURN-ON

CHASSIS GROUND

TO BATTERY +12v

VIA FUSE

PARALLEL MONO

SUBWOOFERS

2-OHMS SVC EACH MINIMUM,

or 4-OHMS DVC EACH MINIMUM