DBI SALA Saflok User Instruction Manual - Page 5

Browse online or download pdf User Instruction Manual for Security Sensors DBI SALA Saflok. DBI SALA Saflok 14 pages. Pole anchor system

Print Page

Step 3.

Raise the Anchor Tube and Vertical Lifeline Rope to a position just below the Pole

anchorage point: Free the trailing end of the Vertical Lifeline Rope of any knots, kinks, or

tangles that might impede raising the Telescoping Extension Pole. Position the butt end of the

Extension Pole on the ground below the anchorage point (Figure 7). Raise the Extension Pole and

attached Anchor Tube to a point just below the desired anchorage by telescoping and locking each

extension of the Extension Pole (Figure 8).

WARNING: When extending the Extension Pole, keep ﬁ ngers clear of the Lock Button Holes to

prevent pinching.

IMPORTANT: To ease raising and lowering of the Telescoping Extension Pole, keep the pole in

a vertical position (Figure 8).

NOTE: Exercise care to protect the Vertical Lifeline Rope from contaminates that will reduce the

rope's dielectric properties. Keeping the unused end of the Vertical Lifeline Rope in the provided

Carrying Bag will help maintain the rope's dielectric properties.

Step 4.

Hang the Anchor Tube over the Pole Anchorage: Lift up on the Extension Pole slightly and

then twist the Anchor Tube into position on the desired anchorage points (Figure 9). When the

Anchor Tube is in position, lower the Extension Pole slightly to Hang the Anchor Tube on the

anchorage points and remove the Installation/Removal Tool (Figure 10).

Step 5.

Retrieve the Eye Splice end of the Vertical Lifeline Rope for anchorage purposes: Insert

the Rope Hook end of the Installation/Removal Tool through the the Eye Splice (Figure 11)

and then retract the Telescoping Extension Pole to pull the Vertical Lifeline Rope through the

Anchor Tube and retrieve the Eye Splice.

Figure 5

Figure 8

Figure 11

Figure 6

Figure 9

NOTE: If an adequate amount

of clear pole top is available,

the Vertical Lifeline Rope can

be pre-choked prior to inserting

the Installation/Removal Tool

and raising the Anchor Tube

to the desired anchorage point

with the Extension Pole.

Figure 7

Figure 10