DBI SALA Flexiguard 8530564 Instruction Manual - Page 13

Browse online or download pdf Instruction Manual for Racks & Stands DBI SALA Flexiguard 8530564. DBI SALA Flexiguard 8530564 18 pages. Concrete mounted jib base
Also for DBI SALA Flexiguard 8530564: Installation Instructions Manual (8 pages)

Print Page

5.0

INSPECTION

5.1

INSPECTION FREQUENCY: The Flexiguard System must be inspected at the intervals de ned in Section 1. Inspection

procedures are described in the "Inspection and Maintenance Log" (Table 2). Inspect all other components of the Fall

Protection System per the frequencies and procedures de ned in the manufacturer's instructions.

i-Safe™ RFID:

Some Flexiguard Systems are equipped with an i-Safe Radio Frequency Identiﬁ cation (RFID) Tag. The RFID Tag can

be used in conjunction with the i-Safe Handheld Reading Device to simplify inspection and inventory control and provide records for you

fall protection equipment. If you are a ﬁ rst-time i-Safe user, contact Capital Safety or visit www.capitalsafety.com.

5.2

DEFECTS: If inspection reveals an unsafe or defective condition, remove the System from service immediately and

contact Capital Safety regarding replacement or repair. Do not attempt to repair the System.

IMPORTANT:

Only Capital Safety or parties authorized in writing by Capital Safety may make repairs to this equipment.

5.3

PRODUCT LIFE: The functional life of the System is determined by work conditions and maintenance. As long as the

product passes inspection criteria, it may remain in service.

6.0

MAINTENANCE, SERVICING, STORAGE

6.1

CLEANING: Periodically clean the System's metal components with a soft brush, warm water, and a mild soap solution.

Ensure parts are thoroughly rinsed with clean water.

IMPORTANT:

Although highly resistant to chemicals and environmental conditions, avoid contaminating the Flexiguard System with

acids, bitumen, cement, paint, cleaning ﬂ uids, etc. If the equipment contacts acids or other caustic chemicals, remove from service and

wash with water and a mild soap solution. Inspect per Table 2 before returning to service.

6.2

SERVICE: Only Capital Safety or parties authorized in writing by Capital Safety may make repairs to this equipment. If

the Flexiguard System has been subject to fall force or inspection reveals an unsafe or defective conditions, remove the

system from service and contact Capital Safety regarding replacement or repair.

6.3

STORAGE AND TRANSPORT: When not in use, store and transport the System and associated fall protection equipment

in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect

components after extended storage.

DISTRIBUTED BY CAI SAFETY SYSTEMS | Phone: (888) 246 6999 | Web: caisafety.com | Email: [email protected]