Dynamix RC 908 EV 35 User Manual - Page 16

Browse online or download pdf User Manual for Media Converter Dynamix RC 908 EV 35. Dynamix RC 908 EV 35 16 pages. Ethernet to v.35 interface converter

Print Page

2. There is some problem with connection between twisted pair and RJ-45

connector.

3. If there are bit errors in V.35 link, please check equipment alarm function,

or test bit error rate of V.35 link by bit error tester.

4. If the traffic through converter increases suddenly, it may cause congestion

within a short time, and result in disconnection of the network. In this case,

the network service with huge amount of traffic should be paused and

restarted after 10 seconds, and the network will be back to normal

condition. However, if a long time disconnection occurs, it is abnormal.

Please check the operation condition of equipments.

To improve the network efficiency, both the Ethernet equipment and the interface

converter shall be set in full duplex mode, with great attention to the matching of

working modes. RC907/908-EV35 may not be suitable for some IP-based image

transmission equipments.

Since the bit rate of pinging large-size packets may exceed transmission capability

of V.35 link, many packet losses may occur. To solve this problem, please try to

increase the timeout parameter of the 'Ping' command.

Network management software can only review, but not conduct

configuration

Answer: The possible reason is that some bits of the dip-switch are not set on the

default status. Please refer to Chapter 4 for details.

RC907/908-EV35 User Guide