ADENDORFF MAC AFRIC SDRILC-007 Original Operating Instructions - Page 6
Browse online or download pdf Original Operating Instructions for Power Tool ADENDORFF MAC AFRIC SDRILC-007. ADENDORFF MAC AFRIC SDRILC-007 9 pages. Cordless brushless driver
Print Page
Four red LED lights are set to indicate the battery power which can be referred to the following table.
Status of Red LED Lights
4 lights lit
3 lights lit
2 lights lit
1 light lit
1 light flickered
Battery Charging
1. Battery Charger
Notice:
The charger applies to charge for specified Li-Ion Battery under normal circumstances.
Make sure that the AC voltage of the power source meets the requirement specified on the
nameplate of the charger.
Due to the continuing program of research and development, the specifications herein are
subject to change without prior notice.
Descriptions of
Icons
Charging Status
Plug the charger into
a proper outlet
During charging
Charge complete
Abnormity occurs on
the battery
The temperature of
the battery is under
0℃ or higher than
50℃
Approx. Battery Power Left
75%～100%
50%～75%
25%～50%
10%～25%
Low level
Icons of Charging
Descriptions of
Indicator Lights
Charging Indicator
Green
Red
Lights
Light
Light
Green light flickers, red
light extinguished
Green light extinguished,
red light keeps
flickering steadily
Green light keeps up
steadily, red light
extinguished
Green and red light
flicker alternately
Green light extinguished,
red light flickers
2. Charging Operation
1. Plug the battery charger into the proper AC power source. The charging indicator light will
flicker in green color and the charger operates in standby mode.
2. Insert the battery pack fully into the battery charger and the charger starts charging.
The battery charger can detect some sort of failure caused by the battery and indicates by the
statuses of the red and green indicator lights.
When a failure occurs, remove the battery and
then insert it into the charger again. If the
failure continues, change with a new battery. If
the new battery can be charged, then the old
battery maybe damaged. If the charging
indicator lights indicate same failure as before
while changing with a new battery, then the
charger maybe damaged, take the charger to
be repaired by qualified serviceman. (Fig. 4)
The following chart lists the relations between the statuses of charging and charging indicator
lights.
Switch Action
CAUTION:
Before inserting the battery into the tool, always check
to see that
the switch trigger actuates properly and returns to the "OFF" position when released.
Model
Input Voltage (AC)
Charging Current
Input Power Frequency
Applicable Battery Cartridge Voltage
(DC)
Applicable Battery Cartridge Capacity
Full Charging Time
Insulation Grade
FFCL18-01
SCHARG-001
FFCL18-03
(FFCL18-04)
220-240V
110-240V
3.0A
50-60Hz
18V
5.0Ah
4.0Ah
≈100min
≈90min
Double Insulation