909 HG2000 Instruction Manual - Page 9

Browse online or download pdf Instruction Manual for Power Tool 909 HG2000. 909 HG2000 14 pages. 2000w heat gun

Print Page

Operation

Follow the steps below to turn on and operate

the HG2000 heat gun.

To operate the heat gun at the

pre-set low temperature 50°C.

1. Check to ensure the slide selector switch is in the Off

position. Plug in the mains cable into a 240V power

outlet, and turn on.

2. Slide the selector switch to position I. The temperature

display will show 50°C, being the set temperature in

position I.

NOTE:

the temperature cannot be altered in setting position I.

3. To start the heat gun, press any one of the 4 buttons

under the display.

4. To change the air flow (speed of the fan): press the top

centre button to increase the fan speed, or the lower

centre button to reduce the fan speed. In total, there are

5 speed settings for the fan.

5. To stop the heat gun, slide the selector switch to the Off

position (O).

To operate the heat gun at higher

temperatures, up to 650°C.

1. Check to ensure the slide selector switch (11) is in the off

position (O). Plug in the mains cable into a 240V power

outlet, and turn the power point on.

2. Slide the selector switch to position II.

The temperature display will show the previous set

temperature in position II.

3. Start the heat gun by pressing

any one of the 4 buttons under

the display.

4. Select the temperature

required by, pressing the

button on the left hand side

marked

to increase the

temperature or the button

on the right marked

decrease the temperature.

NOTE: the temperature range for position II is between

50°C and 650°C.