909 PS120 Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Power Tool 909 PS120. 909 PS120 15 pages. 120w 200mm wetstone sharpener

Print Page

Assembly

The wetstone sharpener is shipped partly assembled,

leaving the sharpening wheel, the tool support bar, tool

holder and water reservoir to be installed prior to use.

CAUTION.

Always ensure that the wetstone sharpener is

switched off and the plug is removed from the power point

before making any adjustments.

Fitting of the sharpening wheel

1. Remove the sharpening wheel

nut (13), along with one of the

large flange washers from the

spindle of the sharpener. The

wheel nut (13) can be removed

by rotating in an anti-clockwise

direction. If necessary, hold the

outer rim of the honing wheel

(2) to prevent the spindle from

rotating.

2. Remove and discard the

cardboard spacer on the spindle.

Check the spindle is fully to

the left of the sharpener

housing and the small spindle

spacer is fully located on the

spindle and sitting against the

housing bearing.

3. While holding the honing wheel

(13) to prevent the spindle

sliding through the housing,

locate the sharpening wheel (1)

onto the spindle so the wheel

sits against the inner large

washer and spacer.

Note,

the spindle must be clean.

4. Still holding the honing wheel, fit

the outer large washer, followed

by the spindle nut, rotating the

nut in a clockwise direction.

Tighten the nut firmly with a spanner, but the

wheel MUST be held

Fitting the tool support

and tool holder

1. Loosen the front tool support

clamps (8) and locate the

tool support bar (7) into the

mounting holes on top of the

machine. The tool support

should be orientated with

the rod extending over the

sharpening stone (1).

Note.

The top mounting holes of the sharpener should only

be used when utilising the sharpening wheel.

Sharpening

Note.

When using the leather honing wheel (2), relocate

the tool support into the mounting holes at the rear of the

machine. The tool support bar must be orientated with the

bar extending over the face of the honing wheel.

2. Slide the adjustable tool holder

(9) onto the rod of the tool

support, as shown. Take care

to orientate the tool holder

as shown opposite; with the

clamping area of the tool

holder (9) towards the centre

of the tool.

honing

to prevent the main spindle rotating.

Honing