909 909210TS Instruction Manual - Page 10

Browse online or download pdf Instruction Manual for Saw 909 909210TS. 909 909210TS 18 pages. 1200w 210mm 8" table saw

Print Page

Unpacking

Due to modern mass production techniques, it is unlikely

that your 909 Power Tool is faulty or that a part is missing.

If you find anything wrong, do not operate the tool until the

parts have been replaced or the fault has been rectified.

Failure to do so could result in serious personal injury.

1. Remove all loose parts from the carton.

2. Remove the packing materials from around the saw.

3. Carefully lift the saw from the carton and place it on a

level work surface.

Before using the machine

WARNING.

Before connecting a tool to a power source

(power point receptacle, outlet, etc.) be sure that the voltage

supply is the same as that specified on the nameplate of

the tool. A power source with a voltage greater than that

specified for the tool can result in serious injury to the user,

as well as damage to the tool. If in doubt, do not plug in

the tool. Using a power source with a voltage less than the

nameplate rating is harmful to the motor.

The machine has to be adjusted so that the height of the

uppermost tip of the blade is just higher than the work piece.

All the guards and safety devices have to be properly fitted

before the machine is switched on.

It must be possible for the saw blade to run freely.

When working with wood that has been processed before,

watch out for foreign bodies such as nails or screws etc.

Remove any such foreign bodies.

Before you actuate the On/Off switch, make sure that the

saw blade is correctly fitted and that the machine's moving

parts run smoothly.

WARNING.

If you have any doubts, get an expert from an

authorised service centre to help you set up the table saw.

It is too dangerous to guess the procedure.

Assembling the side support extension table

CAUTION.

Always pull out the mains power plug before

carrying out any maintenance, conversion or assembly work

on the table saw.

Fitting the side support extension table:

1. Push the round rods through the side holes of the table.

2. Make sure the rods go right through the legs.

3. Push the extension table

lugs (23) into the end of

the rods then screw these

into place.

4. Slide the side table to the

desired distance.

5. Pull down the legs. Make

sure the table saw is on a

level surface and is stable.

6. Once the side table is at the

desired distance, use the lock knobs to lock in place.