909 BN210 Instruction Manual - Page 5
Browse online or download pdf Instruction Manual for Saw 909 BN210. 909 BN210 16 pages. 1400w 210mm (8 1/4") compound mitre saw
Print Page
4) Power tool use and care
a) Do not force the power tool. Use the correct power
tool for your application.
do the job better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch does not turn
it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools.
Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use.
Many accidents are caused by poorly
maintained power tools.
f ) Keep cutting tools sharp and clean.
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to be
performed.
Use of the power tool for operations different
from those intended could result in a hazardous situation.
h) This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
The correct power tool will
Properly
i) Children should be supervised to ensure that they do
not play with the appliance.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
will ensure that the safety of the power tool is maintained.
Additional safety rules for mitre saws
WARNINGS.
Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on the
nameplate of the tool. A power source with a voltage greater
than that specified for the tool can result in serious injury to
the user, as well as damage to the tool.
If in doubt, do not plug in the tool.
•
Using a power source with a voltage less than the
nameplate rating is harmful to the motor.
•
Your tool is double insulated for additional protection
against a possible electrical insulation failure within
the tool.
•
Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the blade.
•
When operating the saw, use safety equipment including
safety goggles or shield, ear protection, dust mask and
protective clothing including safety gloves.
•
Ensure that there is adequate general or localised lighting.
•
Do not use the saw unless the guards are in place.
•
Do not use the saw to cut metal or masonry.
•
Do not let anyone under 18 years operate this saw.
•
Ensure that the operator is adequately trained in the use,
adjustment and operation of the machine.
•
Do not use this saw to cut firewood.
•
Keep the area free of tripping hazards.
•
Report faults in the machine, including guards and saw
blades, as soon as they are discovered.
5
This