Galaxy DX 959 Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Transceiver Galaxy DX 959. Galaxy DX 959 12 pages. Solid state citizens band am/ssb mobile transceiver

Print Page
Galaxy DX 959 Owner's Manual
FREQUENCY RANGE
Channel Channel Frequency Channel Channel Frequency
1
26.965 MHz
2
26.975 MHz
3
26.985 MHz
4
27.005 MHz
5
27.015 MHz
6
27.025 MHz
7
27.035 MHz
8
27.055 MHz
9
27.065 MHz
10
27.075 MHz
11
27.085 MHz
12
27.105 MHz
13
27.115 MHz
14
27.125 MHz
15
27.135 MHz
16
27.155 MHz
17
27.165 MHz
18
27.175 MHz
19
27.185 MHz
20
27.205 MHz
21
27.215 MHz
22
27.225 MHz
23
27.255 MHz
24
27.235 MHz
25
27.245 MHz
26
27.265 MHz
27
27.275 MHz
28
27.285 MHz
29
27.295 MHz
30
27.305 MHz
31
27.315 MHz
32
27.325 MHz
33
27.335 MHz
34
27.345 MHz
35
27.355 MHz
36
27.365 MHz
37
27.375 MHz
38
27.385 MHz
39
27.395 MHz
40
27.405 MHz
- 11 -

PROCEDURE TO RECEIVE AND TRANSMIT

A. MICROPHONE
The receiver and transmitter are controlled by the push-to-talk switch on
the microphone. Press the switch and the transmitter is activated, release
switch to receive. When transmitting, hold the microphone two inches from
the mouth and speak clearly in a normal voice. This transceiver comes
complete with a low impedance dynamic microphone.
B. PROCEDURE TO RECEIVE
1. Be sure that power source, microphone and antenna are connected to the
proper connectors before going to the next step.
2. Turn unit on by running VOL knob clockwise on transceiver.
3. Set the VOL for a comfortable listening level.
4. Set the MODE switch to the desired mode.
5. Listen to the background noise from the speaker. Turn the SQ knob
slowly clockwise until the noise just disappears. Leave the control at this
setting. This SQ is now properly adjusted. The receiver will remain quiet
until a signal is actually received. Do not advance the control too far or
some of weaker signals will not be heard.
6. Set the CHANNEL selector switch to the desired channel.
7. Set the RF GAIN control fully clockwise for maximum receive gain.
C. RF POWER CONTROL
This feature allows for the adjustment of the RF power output continuously
over the range of 1 to 4 watts in AM and 4 to 12 watts in USB or LSB.
D. PROCEDURE TO TRANSMIT
1. Select the desired channel of transmission
2. Set the MIC GAIN control fully clockwise.
3. If the channel is clear, depress the push-to-talk switch on the microphone
and speak in a normal voice.
- 12 -