Autonics KN-1000B Series Product Manual - Page 3
Browse online or download pdf Product Manual for Measuring Instruments Autonics KN-1000B Series. Autonics KN-1000B Series 6 pages. Bar graphic temperature indicators
Print Page
Dimensions
• Unit: mm, For the detailed drawings, follow the Autonics website.
• Below is based on KN-1000B series.
36
■ Bracket
52.1
Connections
■ KN-10□□B
'
10
32
80
■ Panel cut-out
33
+0.6
0
■ KN-12□□B
■ KN-14□□B
Errors
Display Description
Flashes when input sensor is disconnected or
sensor is not connected.
BURN
Flashes when PV is higher than input range.
HHHH
Flashes when PV is lower than input range.
LLLL
Flashes when there is an error of setting value
ERR
Mode Setting
Monitoring mode
→
[MODE]
RUN
→ Program mode setting
[MODE] over 3 sec
→
Digital input key
[▲] + [▼] over 3 sec
Supply the power with
→
Parameter reset
pressing [M] + [◀]
Input specification
Supply the power with
→
pressing [M]
01) Refer to 'Communication Parameter Setting' for checking the details about communication.
Parameter Setting
• Some parameters are activated/deactivated depending on the model or setting of
other parameters. Refer to the descriptions of each item.
• [MODE] key: Move to next item after saving
[◀] key: Select parameter / Move digits
[▲], [▼] key: Select parameter / Change setting value
• Return to the RUN mode without saving when there is no key input for more than 30
seconds.
■ Monitoring Mode
Parameter
Display Default Setting range
AL1 alarm
1-1
temperature
AL1
09(9
AL2 alarm
1-2
temperature
AL2
09(9
AL3 alarm
1-3
temperature
AL3
00)1
AL4 alarm
1-4
temperature
AL4
00)1
1-5
High peak
hPEK
----
1-6
Low peak
lPEK
----
Troubleshooting
Check input sensor status.
When input is within the rated input
range, this display disappears.
Check the setting condition and
reset.
[MODE] over 3 sec
setting
[MODE] over 3 sec
Auto
Auto
Auto
expansion
01)
Sensor input: within using range
Analog Input: L-SC ≤ AL□ ≤ H-SC
[4 alarm output model]
Same as 1-1/2 AL1/2 alarm temperature
Check only (not available to set)
Displays high/low peak (Max./Min.
input) value
• Initial high/low peak is saved after 2 sec
from supplying the power.
• Value reset: [▲] + [▼] key over 3 sec in
1-5/6 High/Low peak parameter
→
→
RUN
→
→
→
Condition
2-15/17/19/21
AL-1/2/3/4
alarm
operation:
AT1, AT2
-