DYNAPAR M21 Series Installation Manual - Page 3

Browse online or download pdf Installation Manual for Media Converter DYNAPAR M21 Series. DYNAPAR M21 Series 6 pages.

Print Page

Preliminary Step

Remove center label:

Carefully detach the center label as shown. The label

contains information about the PPR of the encoder.

For future reference, it should be attached to the

unit's side body or cover

Center Hub

Important:

In preparation for mounting the M21 encoder on a

motor, the center hub assembly must be centered

properly. Press inward on the hub while moving in

all directions to be sure hub is fully seated. Once

centered, maintain inward pressure on the hub and

proceed to the next step.

Polígono Industrial O Rebullón s/n. 36416 - Mos - España - [email protected]

Application Assistance 1.800.234.8731 (847.662.2666)

Prepare Motor

Locate mounting area:

Locate stub shaft and tapped holes where encoder is

to be attached. Be sure shaft is of sufficient length

to extend into hub clamping area (see specifica-

tions).

For Use with Commutation

Tracks Only

Electrically lock motor's rotor:

The manufacturer of the motor should be

consulted regarding the rotor locking procedure.

Voltage should remain on through step 9a.

If installation does not utilize

commutation tracks, skip this

step

+34 986 288118

Servicio de Att. al Cliente

Page 3