Dynaphos CraftLine GS-300 Instruction Manual - Page 2

Browse online or download pdf Instruction Manual for Camera Flash Dynaphos CraftLine GS-300. Dynaphos CraftLine GS-300 8 pages. Studio flash

Print Page

Savety

Thank you for choosing DYNAPHOS studio lighting equipment! Before you proceed further, please read the

instruction manual.

Attention! Please, follow the savety instructions!

• Keep out of reach of children!

• Make sure that the power outlet you plug the flash is working correctly.

• Do not disassemble or modify! There are high-voltage components inside the unit. Repairs should only be

performed by authorised service personnel!

• Do not touch the lamp cap when the flash or modeling lamp is working due to risk of burns or electic shock!

• Disconnect the flash from the power supply when mounting accessories on or off or when you're cleaning

the flash unit.

• Durint operation, some of the light control accessories may be heated to high tempetures! Wait to cool

down before you mount them off.

• During operation, do not cover the flash! Make sure that the flash unit will not be activated in the vicinity

of inflammable gases or liquids. Risk of explosions!

• Do not expose the flash unit to water drops and splashes!

• In every 30 continuous flashes at full power, leave the flash to cool down for about 3 minutes. Overheating

will occur if it is used continuously without cooling down.

• Do not flash directly into eyes from a close distance! Direct flashing into the eyes of person or animals can

cause damage to the retina and severe disruption of the vision – up to and including permanent blindness!

• If the housing has been damaged in such a way that internal components are exposed, the flash unit may no

longer be used. Disconnect from the power supply! Do not touch any internal components. HIGH VOLTAGE!

• Use only light controlling accessories autorized by DYNAPHOS Ltd.