Autonics PSAN-L1CPA Series Manual - Page 5
Browse online or download pdf Manual for Measuring Instruments Autonics PSAN-L1CPA Series. Autonics PSAN-L1CPA Series 13 pages. Small size, 1/2,000 resolution connector type digital pressure sensor
Also for Autonics PSAN-L1CPA Series: Manual (2 pages)
Print Page
PSAN Series
Control output diagram
Analog output (Voltage output PSAN-
● NPN open collector output type
Over current
protection
circuit
Over current
protection
circuit
1kΩ
※ In case of analog voltage output type models short-circuit protection is not embodied. (
Do not connect with power source or load directly.
※ Be careful with input impedance of connecting devices when using analog voltage output type models.
※ Be careful with voltage drop due to cable resistance when extending sensor cable.
Hold/Auto shift input (PSAN-
● NPN open collector output type
Over current
protection
circuit
Over current
protection
circuit
Front panel identification and function
3
5
6
Setting
Press
key
Parameter
over 3sec.
setting
Preset value
setting
Press
key
Forced output
control mode
setting
Press
key
Peak hold
over 3sec.
Press
+
Zero-point
keys over 1sec.
adjustment
E-8
(Brown)+V
Load
(Black)OUT1
Load
(White)OUT2
12-24VDC
(Orange)
Analog output
voltage/current
0V(Blue)
(Brown)+V
Load
(Black)OUT1
Load
(White)OUT2
12-24VDC
(Orange)
Hold/Auto shift
input
0V(Blue)
1. Range of rated pressure : It is possible to change the pressure unit in Pressure sensor.
1
2. 4digit LED display(Red) : sed to indicate measured pressure value, setting value and error
2
3. Output1 indicator(Red) : Output 1 is ON, LED will be ON.
4
4. Output2 indicator(Green) : Output 2 is ON, LED will be ON.
5.
key : Used to enter into Preset/Parameter setting mode and to save Setting mode.
6.
,
key : Used to set parameter and preset, peak value check mode, function setting or output
operation mode.
+
key : Used for zero point adjustment function by pressing
simultaneously in RUN mode.
Pressure
Output operation
unit setting
mode setting
Detection level 1 setting (out1)
The forced output control mode is applied with pressign
mode( fOUT ) in output operation mode( OUtM ) parameter. For more detailed information, refer to '● Forced
output control mode' '
High peak
value check
Zero-point adjustment
V- , Current output PSAN-
● PNP open collector output type
Over current
protection
circuit
Over current
protection
circuit
1kΩ
H-
type)
● PNP open collector output type
Over current
protection
circuit
Over current
protection
circuit
Please use different unit as label for your application.
message.
Output
Response
type setting
time setting
Detection level 2 setting (out2)
Output operation mode'
Low peak
value check
(In case of Hold/Auto shift input type model)
(Brown)+V
(Black)OUT1
(White)OUT2
(Orange)
Analog output
voltage/current
0V(Blue)
: For voltage output type only.)
(Brown)+V
(Black)OUT1
(White)OUT2
(Orange)
Hold/Auto shift
input
0V(Blue)
+
Analog output scale and
Hold/Auto Shift input setting
key after selecting forced output control
Auto shift input setting
A-
type)
12-24VDC
Load
Load
12-24VDC
Load
Load
keys over 1 sec.
Key lock
setting