Dynaphos Expert QS-600 Instruction Manual - Page 7

Browse online or download pdf Instruction Manual for Lighting Equipment Dynaphos Expert QS-600. Dynaphos Expert QS-600 8 pages. Expert qs series

Print Page

- mount the sender in the camera HotShoe connector with the control

panel towards to you and tighten the nut

- choose a working channel via the selector

from the power switch

- place the receiver in the USB sync port

and set on the same channel as the sender (check the further picture).

From the selector

choose a working group. For work with more than

one flash, you'll have to place a corresponding number of additional

(product № 010289)

receivers FTR-16

the same channel as the sender. Preferably, the receiver of each flash

has to be set on a different group in order each flash to be control

separately.

- choose a working group (a flash) from the selector of the sender; to

change the power output of the flash use the "-/+" button 5; through

the "Lamp" button

10.

through the "Buzz" button

through the "Test" button

- Please notice, that the "Set" button

series.

- when pressing a button the indicator

pen place a new batteries and try again.

- after finnishing work turn off the receiver from the power switch

- keep the antenna

10.

for each flash and set them on

you can turn on or off the modeling light;

you can turn on or off the sound signal;

12.

you trigger the flash or make a test flash.

is working only with WITSTRO

11.

must flash, if this don't hap-

save from mechanical damage

and turn on the sender

(check page 2)

of the flash

Guide