Hifonics TITAN TS300R Manual - Page 6

Browse online or download pdf Manual for Car Stereo System Hifonics TITAN TS300R. Hifonics TITAN TS300R 8 pages. Bassreflex subwoofer systems

Print Page

ENGLISH

POWER RATING

The HiFONICS TITAN TS subwoofer enclosures are designed for high bass

levels. Anyhow it is possible, that unsatisfying sound characteristics could be

caused by too low or too high amplifier power. In certain circumstances this

even can cause a damage to the loudspeakers.

It is recommended to choose rather a more powerful amplifier (ca. 15-20%

more Watts RMS than the max. RMS power rating of the woofer) and to use

the amplifier not at the maximum output level (low distortion factor, good sound

characteristics). A weaker amplifier at the maximum level causes worse sound

characteristics due to the higher distortion factor.

Never crank up the output volume of your amplifier to the maximum level or run

the amplifier into the clipping range. If the sound is distorted and not clean, turn

back the level until the distortions disappear.

Please note the following recommended power ratings:

TS250R

One Amplifier with approx. 240 to 360 Watts RMS @ 4 Ohms.

TS300R

One Amplifier with approx. 300 to 500 Watts RMS @ 4 Ohms.

The HiFONICS TITAN TS subwoofer enclosures have no integrated limiter or

clipper, which is limiting the level upwards. Overamplified bass peaks leads in-

evitably to a burn out of the voice coil of the woofer. A burn out of the voice coil,

caused by clipping/overamping is not covered by the usual warranty.