Galaxy Equipment 177GB440 User Manual - Page 3

Browse online or download pdf User Manual for Blender Galaxy Equipment 177GB440. Galaxy Equipment 177GB440 7 pages. Commercial blender with toggle controls

Print Page
Galaxy Equipment 177GB440 User Manual
OPENING & INSTALLATION INSTRUCTIONS
• Inspect blender for any damage such as cracks or dents in base and container.
• Remove all plastic wrap and packaging material before use.
• Do not install blender next to or above source of heat, such as an oven or radiator.
This could cause the blender to operate improperly and could shorten life of
electrical parts.
• Install blender on a level countertop surface.
• Plug into a grounded 120V outlet, free of other appliances and equipment.
• Outlet should be located so that the plug is accessible when microwave is in place.

CLEANING INSTRUCTIONS

GENERAL CLEANING
1. Remove the container from the blender base and remove the jar cover.
2. Add cleaning solution to the container.
(Non-sudsing detergent and hot water (less than 115°F))
3. Scrub and flush out the container interior, cover, and filler cap to remove food
residue and empty the container.
4. Fill container 1/4 full with fresh cleaning solution and place it on the base.
5. Replace the cover on the container and run the blender on 2 - HIGH speed for 2
minutes.
6. Repeat step 3 & 4 using clean rinse water (95°F).
7. Wipe down the container, filler cap, and cover with a soft cloth or sponge,
dampened with fresh cleaning solution.
8. Wipe the exterior of the base with a damp cloth or sponge.
The base contains electrical components -
DO NOT immerse in water or cleaning solution.
DO NOT use a high-pressure washer or dishwasher to clean the base.
9. Allow all parts to air dry.
SANITIZING
1. Wash container as instructed above.
2. Fill container 1/4 full with preferred sanitizing solution and place on base.
3. Replace cover and filler cap and run on 1 - LOW speed for 2 minutes, then empty
the container.
4. Wipe the container exterior with a soft cloth or sponge dampened with sanitizing
solution.
5. Remove any remaining moisture from cutter assembly by placing empty container
on base and running on 2 - HIGH speed for 10 seconds.
6. Allow all parts to air dry.
NOTE: DO NOT rinse container, cover, or filler cap after sanitizing.
7. When ready to use, rinse with clean water.
User Manual
- 3 -