dynarex DynaRide 15009-12DFR Manual - Page 5

Browse online or download pdf Manual for Wheelchair dynarex DynaRide 15009-12DFR. dynarex DynaRide 15009-12DFR 10 pages. Pediatric wheelchair with footrest

Print Page

USES AND ADJUSTMENTS

TO OPEN CHAIR

Open wheelchair by tilting it to one side and pushing down on seat rail until

fully opened.

TO CLOSE CHAIR

Fold foot plates to vertical position. Grab seat with both hands at front and

back edge and lift—OR tilt to one side and lift up on seat rail.

TO ADJUST WHEEL LOCKS

Adjustments to locks are made by loosening or tightening nut on the carriage

bolt. Wheel lock shoe should be embedded at least ⅛" when locked. Adjust

by sliding clamp toward rear wheel while handle is engaged in locked

position. Tighten nut and bolt to secure in position. Test to ensure correct

locking action before actual use.

TO REMOVE SWING-AWAY FOOTRESTS

Release lock by pushing on the front rigging

release lever. Move swing-away footrest out and

sideways. Lift to remove.

TO REMOVE ARMREST

Remove armrest by depressing spring button and

lifting arm out of front socket.

TO ADJUST FOOTRESTS

When adjusting length of footrests, user should be

Fig. 3

sitting in wheelchair with feet on the foot plates.

First lift black tab (A) and then depress both push

pins (B). Raise or lower footplate to preferred

position to provide optimal support of thighs. Front

rigging should not be so low that it causes

uncomfortable pressure to thighs at front of seat

upholstery. Position footrest at least 2½" from the

ground to ensure sufficient clearance. (Fig. 3)

TO ADJUST PUSH HANDLES

To raise or lower push handles, release ratchet handle and adjust to desired

height. Then tighten ratchet handle to secure in place.