iHealth BP7 Owner's Manual - Page 15
Browse online or download pdf Owner's Manual for Blood Pressure Monitor iHealth BP7. iHealth BP7 16 pages. Wrist
Also for iHealth BP7: Quick Start Manual (4 pages), Owner's Manual (16 pages)
Print Page
Radiated RF
IEC 61000-4-3
Note 1 At 80 MHz and 800 MHz, the higher frequency range applies.
Note 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected
by absorption and reflection from structures, objects and people.
a) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless)
telephones and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast
cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due
to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured
field strength in the location in which the monitor is used exceeds the applicable RF compliance
level above, the monitor should be observed to verify normal operation. If abnormal
performance is observed, additional measures may be necessary, such as re-orienting or
relocating the monitor.
b) Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
For ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING
Recommended separation distances between portable and mobile RF communications
equipment and the Wireless Blood Pressure Wrist Monitor
The Wireless Blood Pressure Wrist Monitor is intended for use in an electromagnetic environment
in which radiated RF disturbances are controlled. The customer or the user of the Wireless Blood
Pressure Wrist Monitor can help prevent electromagnetic interference by maintaining a minimum
distance between portable and mobile RF communications equipment (transmitters) and the
monitor as recommended below, according to the maximum output power of the communications
equipment.
Rated maximum
output
power of
transmitter
W
3 V/m 80 MHz to
2.5 GHz
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
=
d
1
2 .
P
3 V/m
=
d
1
2 .
=
d
2
3 .
Where P is the maximum output
power rating of the transmitter in
watts (W) according to the
transmitter manufacturer and d is the
recommended separation distance in
meters (m).
Field strengths from fixed RF
transmitters, as determined by an
electromagnetic site survey,
be less than the compliance level in
each frequency range.
Interference may occur in the vicinity
of equipment
marked with the following symbol:
Table 4
m
80 MHz to 800 MHz
=
d
1
2 .
P
80 MHz to 800 MHz
P
800 MHz to 2.5 GHz
P
a
should
b
800 MHz to 2,5 GHz
=
d
2
3 .
P
15