High Link GF302 User Manual - Page 11

Browse online or download pdf User Manual for IP Phone High Link GF302. High Link GF302 15 pages. Voip phone

6.9 Mute

During a current call, press MUTE Key. The LED on the phone lights up, indicating that the other party cannot hear you.

To cancel this set, press MUTE Key again, LED of MUTE out

When Phone on hook, press Mute/DND Key to trigger the phone to DND status. The LED of Mute lights up indicating that

phone will send the busy tone to the caller during an incoming call.To cancel this set, press Mute/DND Key again, LED of

MUTE out.

The incoming messages will be indicated by a flashing message LED. Press MESSAGE key to trigger the phone to call the

pre-set service number The flashing LED will be out after checking voice messages.

1. Enter the menu mode: Press MENU key to main menu. Select "PHONE SETTINGS" and press OK key to into next

submenu.

2. Select DEFAULT item: Use UP or DOWN to scroll to "Default Cfg " item.

3. Restore factory configuration: Press OK key to confirm.AR168X SIP Phone will reboot automatically and restore to

factory default settings.

Prepare the settings file named [MAC].txt in the upgrade server. [MAC] is MAC address of the phone to be upgraded, such

as 00-18-1f-01-00-3a.txt. a settings file can be created by getopt.bat command and for more details see getopt section in

chapter 5. A settings file example:

config_id=0008 (as a flag for settings file)

mac_address=0x00,0x18,0x1f,0x01,0x00,0x3a

...............

provision_server=192.168.1.251

provision_port=8080

provision_ttl=60

prov_filename=gf302_iax2_us_009011.bin （ for setting a file name for upgrading the firmware）

.............

digit_dialing=0

Save the firmware file for upgrading in the server. Rule of name is gf302_protocol_language_version.bin

Please choose the keyboard or WEB orders and set Auto-provisioning server address and server port. For more details see pho

After the properly setting phone starts, it will get the settings file from the upgrade server. If onfig_id in the settings file is

different from the one in the phone, the phone will be updated with all the parameters in the file.

After setting parameters, the phone will restart to make the parameter valid. If prov_filename item in new parameters is

different from the firmware filename in the phone, the phone will connect with the server to get the firmware file and update

automatically.

When "auto-upgrade interval" in the phone settings expires, the phone will connect with the server to get [MAC].txt

automatically. If config_id is the same with the one in the phone, it will stand by.