DCA M1Q-FF-85 Operation Instructions Manual - Page 8
Browse online or download pdf Operation Instructions Manual for Power Tool DCA M1Q-FF-85. DCA M1Q-FF-85 10 pages.
Print Page
For splinter-free cuts, the splinter
guard can be used.
To install the splinter guard, simply
press it into the base. (Fig. 8)
Plunge Cutting
CAUTION:
Apply plunge cutting only when working on soft materials, such as wood,
aerated concrete, gypsum plaster boards, etc.!
Use only short saw blade for plunge cutting.
Pull out the saw blade only until it
comes to a complete stop to avoid
kickback when make a plunge cut.
Place the tool with the front edge of
the base onto the workpiece and
switch on. Firmly hold the tool against
the workpiece while tilting the tool and
slowly plunge the saw blade into the
workpiece. (Fig. 9)
When the base fully lays on the
surface, continue sawing along the
cutting line. (Fig. 10)
-13-
Metal Cutting
Always use a suitable coolant (cutting oil) when cutting metal or similar materials.
Failure to do so will cause significant blade wear.
Guide Rule (optional accessory)
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or
removing accessories.
The combined circle cutter/parallel guide
rule enables repeatedly cuts in a certain
width conveniently.
To install the guide rule, insert it into the
rectangular hole on the side of the base.
Slide the guide rule to the desired cutting
width position. (Fig. 11)
Certain radius circular cutouts can be
made conveniently and repeatedly by
using the combined circle cutter/parallel
guide rule. (Fig. 12)
With the combined circle cutter/parallel
guide rule parallel cuts or circular cutouts in
materials of up to 30 mm thickness can be
made.
-14-