DCA S1P-FF03-180 Operation Instructions Manual - Page 5

Browse online or download pdf Operation Instructions Manual for Sander DCA S1P-FF03-180. DCA S1P-FF03-180 8 pages.

Print Page

Higher speed is obtained when the dial

is turned in the direction of number 6.

And lower speed is obtained when it is

turned in the direction of number 1. (Fig.

Refer to the table for the relationship

between the number settings on the dial

and the approximate tool speed.

CAUTION:

If the tool is operated continuously at low speeds for a long time, the motor will

get overloaded, resulting in tool malfunction.

The speed adjusting dial can be turned only as far as 6 and back to 1. Do not

force it past 6 or 1, or the speed adjusting function may no longer work.

Sanding Operation

Set the speed to high for maximum

efficiency if this tool was used as a sander.

Hold the tool firmly. Turn the tool on and

then apply the abrasive disc to the

workpiece.

Apply slight pressure only.

In most

applications, the weight of the tool alone is

sufficient for effective sanding. Too much

pressure will result in reduced rotational speed, inferior surface finish, and

overloading which could reduce the life of the tool.

Number

Speed (rpm)

1000

1370

1890

2440

2950

max

3600

-7-

Do not apply the entire surface of the abrasive disc to the workpiece. In general,

keep the abrasive disc at an angle of 15 to 30 degrees to the workpiece surface. (Fig.

CAUTION:

Always wear safety goggles or a face shield during operation.

Never switch on the tool when it is in contact with the workpiece, it may cause an injury

to operator.

Never run the tool without the abrasive disc. You may seriously damage the pad.

Polishing Operation

Set the speed to low for maximum efficiency

if this tool was used as a polisher.

Hold the tool firmly. Turn the tool on and

then

apply

the

wool

bonnet

workpiece.

Apply slight

pressure only.

Excessive

pressure will result in poor performance and

premature wear to wool bonnet.

In general, keep the wool bonnet at an angle of 15 to 30 degrees to the workpiece

surface. (Fig. 6)

Sanding disc, polishing compound or wax should be selected in accordance with the

material and the desired surface finish. Maximum polishing effect will be attained by

following the following method:

Preliminary polishing with sander using a fine-grain sanding disc.

Polishing with wool bonnet using polishing compound and/or wax. Apply a small

quantity of compound and/or wax on material surface and polish with the wool bonnet.

CAUTION:

Always wear safety goggles or a face shield during operation.

the

-8-