Autool SDT205 User Manual - Page 8
Browse online or download pdf User Manual for Smoke Alarm Autool SDT205. Autool SDT205 9 pages. Smoke leak detector
Also for Autool SDT205: User Manual (3 pages)
Print Page
Easy Installation
•
After unpacking, please move the machine onto the table and
turn the machine to the back side.
•
Take out the power cord from the accessory box and connect it
to the power interface.
•
Take out the smoking hose from the accessory box and
connect it onto the smoke outlet.
Easy Connection
•
Power connection: Connect the positive and negative poles of
the power cord to the positive and negative poles of the car
battery.
Operational Steps
Operational Steps for Air Intake System Test
•
Open the air filter cover and take out the air filter.
•
Take out the inflatable bladder from the accessory box and
continue to squeeze it until the inflated diameter of the rubber
bladder matches the diameter of the air inlet.
•
Remove the oil filler cap, add 10ml of test oil into it, and tighten
the cap.
•
Turn on the power switch. Then press the air mode button and
the smoke mode button respectively.
•
Block the smoke nozzle and watch the pressure gauge.
•
When the pressure reaches 0.8kg / cm2, please connect it to
the inflatable bladder.
•
After that, you can find out if there is smoke coming out from
the leak point of the air intake system.
13
Attention:
It is Not recommended to add more than 10ml of the test oil into
the detector; otherwise it will make the smoke generator stop
working, and there will be no smoke coming out or even oil spill.
When the product is used for a long time, the internal
temperature of the machine is too high and the overheating
protection indicator will be turned on. Please disconnect the
power supply immediately to make the device stop working.
Operational Steps for EVAP System Test
Find the carbon canister on the car, and disconnect the fuel
inlet/outlet tubing.
Take out the special adapter for EVAP system from the
accessory box and connect it to the tubing you want to test.
Remove the oil filler cap, add 10ml of test oil into it, and tighten
the cap.
Turn on the power switch. Then press the air mode button and
the smoke mode button respectively.
Block the smoke nozzle and watch the pressure gauge.
When the pressure reaches 0.8kg / cm2, connect the smoke
nozzle with the special adapter for EVAP system.
After that, you can find out if there is smoke coming out from
the leak point of the EVAP system.
Attention:
Please make sure there are no open flames in the process of
EVAP system test.
14