Autopage XT-33 Operation Manual - Page 8

Browse online or download pdf Operation Manual for Remote Starter Autopage XT-33. Autopage XT-33 18 pages. Professional 2-way am/am remote car starter & keyless entry system with two-way serial port data link

Print Page

A maximum of six cycles can occur.

ENTER:

1. Press the

vehicle is running the parking lights will turn 'ON'.

2. Immediately press the

will flash (3) times. The siren chirps (3) times. The vehicle is now

programmed to start every (3) hours.

3. Press the brake pedal to stop the vehicle running.

Exit the timer start:

Timer start can be exited manually as follows:

1. Repeat the Enter Steps from above.

1. Make sure the remote start system is not operating the engine.

2. Turn the ignition on. The LED and parking light will flash (4) times. The

siren chirps (4) times.

SHUTDOWN INPUT FOR REMOTE STARTER:

If any of the following conditions exist while the system is operating, the

engine will not start or will shut down immediately:

1. The hood is opened.

2. The brake pedal is pressed.

3. The optional remote start enable toggle switch is in the OFF position.

4. Engine is over-revved. {"Tachometer checking type" only}

5. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.

6. Transmitter

7. The vehicle refused to start running after {3} unsuccessful attempts.

DISABLING THE REMOTE START SYSTEM: (If Optional toggle switch is

installed)

This feature allows your system's remote start unit to be temporarily

disabled to prevent the vehicle from being remote started accidentally. This

feature is useful if the vehicle is being serviced or stored in an enclosed

area. To disable the remote start, move the optional remote start enable

toggle switch to the OFF position. Valet mode can also be used.

LCD REMOTE CONTROL TRANSMITTER:

button once to remote start the vehicle. As soon as the

button then press

button is pressed.

XT-43 LCD TRANSMITTER OPERATION:

button. The parking light