Autopage MA-200 Installation Instructions Manual - Page 3

Browse online or download pdf Installation Instructions Manual for Car Alarm Autopage MA-200. Autopage MA-200 8 pages. 2-way remote control motorcycle alarm
Also for Autopage MA-200: Operation Manual (13 pages)

Print Page

LED Indicator

Valet Switch

Transmitter

Antenna

Black Antenna Wire

H1: MAIN 6 PIN WIRE HARNESS:

1. W hite W ire: Turn Indicator Relay Output

2. Red / W hite Wire: Turn Indicator Relay Power Input

3. White Wire: Turn Indicator Relay Output

4. Black W ire: Ground to Motorcycle Frame

5. Brown W ire: Positive Output To Siren

6. Red W ire: +12V To Constant Battery Source

H2: 7 PIN MINI CONNECTOR WIRE HARNESS:

1. Orange Wire: 200mA Grounded when armed

2. Green Wire: Zone 3 / Close Loop Input

3. Pink Wire: (-) 200mA Horn Drive output

4. Blue Wire: Zone 2 / Ground Instant Trigger

5. Violet Wire: (-) 200mA Timer Control Channel 4 Output

6. Gray Wire: (-) 200mA Timer Control Channel 3 Output

7. Yellow Wire: Zone 5 /To Ignition Switch +12V

CAUTION: Do not connect the wire harness to the control module until all wiring to motorcycle is complete.

H1. MAIN WIRE HARNESS:

H 1/1 & 3. White wire – (+) Turn Indicator Relay Output (5A output for each) –

Only one of these wires need to be used (they are interchangeable) if the motorcycle or recreational

vehicle) has a front running light. The wire should be connected to the (+) parking light wire.

MA200 IN REV.A

WIRING DIAGRAM

H7 2 Pin

White

H1 6 Pin

H1:

Main 6 Pin White harness

White

H6 2 Pin

Blue

H2 7 Pin

H5 4 Pin

H2:

7 Pin White Mini Connector

White

Blue

H3 4 Pin

White

H3:

4- Pin Molex Connector

Turn Indicator

WIRING

Oct/23/2006

"Acc"

"Start"

"On"

"Off"

Starter

10A Fuse

3A Fuse