Gale Pacific Coolaroo SOLAR MOTORISED 490928 Assembly & Operating Instructions - Page 5

Browse online or download pdf Assembly & Operating Instructions for Window Blinds Gale Pacific Coolaroo SOLAR MOTORISED 490928. Gale Pacific Coolaroo SOLAR MOTORISED 490928 8 pages. Exterior blind

Print Page
Pairing the remote control for up to 5 blinds
The blind has been pre-programmed to Channel 1 on the remote control (as illuminated on the channel
indicator). Up to 4 additional blinds can be programmed to the same remote control by following these
steps.
NOTE: You have 10 seconds to pair each blind before the remote control resets and you will need to start
the sequence again.
1.
Hold motor program
button for 3 seconds.
Motor will beep once and
rotate (back and forth).
Repeat the above steps to pair additional blinds to the remote control.
Once all blinds have been programmed to the remote they can be operated independently or all at the
same time. Press the channel selector button to choose a single blind (1 to 5), or, when all 5 channels are
illuminated all blinds will operate together.
Setting an additional stop position
The blind has been pre-programmed with top and bottom limit positions.
To set an additional stop position, follow these steps.
1.
Select the desired
additional blind position
using the up, down and
stop buttons on the
remote control.
button
Stop
button
Down
button
2.
Press channel
selector button to
choose the desired
channel for pairing.
2.
When the blind is in
the desired position,
press the program
button on the back of
the remote.
Program
button
Up
Motor will beep
once and rotate
(back and forth).
3.
Press the remote
control program button
once. Motor will beep
once and rotate (back and
forth). When the motor
Channel
stops press it again.
indicator
Program
button
Channel
selector
button
3.
Press the stop
button once.
Stop
button
Motor will beep
once and rotate
(back and forth).
4.
Press the up
button once.
Up
button
Motor will reverse
and beep six times to
complete the pairing.
4.
Press the stop
button one last time.
Up
button
Motor will beep 3 times,
signaling that the
additional position is set.