Autopage AP4000EX Operating Instructions Manual - Page 4

Browse online or download pdf Operating Instructions Manual for Pager Autopage AP4000EX. Autopage AP4000EX 17 pages. Access point
Also for Autopage AP4000EX: Operation And Installation Manual (15 pages)

Print Page

INSTALLATION INSTRUCTIONS

BEFORE INSTALLATION

BEFORE BEGINNING THE INSTALLATION, THOROUGHLY READ OVER THIS MANUAL TO BECOME

FAMILIAR WITH ALL OF THE INSTALLATION STEPS.

SUGGESTED INSTALLATION EQUIPMENT

[ ] Electric, and/or battery operated drill.

[ ] Assorted drill bits

[ ] Phillips and straight blade screwdrivers.

[ ] Needlenose pliers.

[ ] Diagonal cutters.

[ ] Wire cutter/stripper.

[ ] Wire connector crimping tool.

[ ] Soldering iron, or gun.

[ ] Voltmeter. (SEE CAUTIONS BELOW)

SUGGESTED INSTALLATION SUPPLIES

[ ] One NEW "AA" cell alkaline battery. (*)

[ ] Assorted, insulated lug and splice connectors.

[ ] Vinyl electrical tape.

[ ] Plastic tie wraps. (Cable ties)

[ ] Plastic shrink wrap and protective tubing.

[ ] Electrical diagram for the vehicle you are working on.

[ ] Solder approved for automotive use.

(*) The battery packed with the AP4000EX is a "test only" battery. This battery should be replaced with a new battery

as AutoPage cannot guarantee maximum voltage.

IT IS STRONGLY RECOMMENDED THAT A VOLTMETER BE USED FOR CHECKING ALL ELECTRICAL

CIRCUITS IN THE VEHICLE, INSTEAD OF A COMMON TEST LIGHT! Test lights can cause vehicle computer

damage if the wrong wires are probed, and can cause air bag systems to activate (deploy). Either of the above will

cause extensive damage to the vehicle, resulting in costly repairs. Pay close attention to all caution labels in the vehicle.

AutoPage will assume absolutely no responsibility whatsoever for this, or any other damage done to the vehicle, or any

personal injury due to improper installation. Refer to the limited warranty for details.

A suitable place must be located to permanently install the AP4000EX main control unit. This should be an area that is

not exposed to excessive temperatures or moisture. DO NOT INSTALL THE CONTROL UNIT UNDER THE

HOOD OF THE VEHICLE! IT IS NOT WATERPROOF. WATER DAMAGE WILL NOT BE COVERED

UNDER THE WARRANTY.