High Tech Pet Products BLUEFANG X-22 Installation, Operating And Training Manual - Page 12

Browse online or download pdf Installation, Operating And Training Manual for Pet Care Product High Tech Pet Products BLUEFANG X-22. High Tech Pet Products BLUEFANG X-22 16 pages. Super electronic dog fence

Print Page

______________________________________________________________________________________

www.hightechpet.com

High Tech Pet Products, Inc.

The TX- casing is assembled in two parts, the mounting base and the

electronics console. In the package, they are assembled together. You must

simply pulling them apart. Hold the mounting base in one hand and the

A. Using the four mounting screws provided, mount the Mounting Base in

its desired location.

B. If you have purchased the optional back-up battery, install it in the back

of the electronics console by plugging in the connector and snapping

the battery into place. If you did not purchase the back-up battery it is

easy to install it at a later date should you choose to do so.

Line up the snap in mounting posts in the Mounting Base with the

snap together.

AC Adapter: Plug the 16 VDC adapter into a standard 115 Volt outlet and

connect the DC plug into the receptacle on the lower right of the Base

Station Transmitter.

STEP 4: Test The Receiver Collar Radio Function

You should test the receiver by installing a 24 inch long test loop of wire

across the quick connect cable terminals. Set the Power Boost switch

to normal (NOR) and switch on the Base Station Transmitter. Bring the

receiver close to your test loop. A beeping sound emitted by the receiver

collar indicates the system is working properly. Note that with such a short

loop the range will only be a few inches.

STEP 5: Prepare Twisted Wire Lengths First

Prepare the twisted lengths of wire. From your system layout sketch,

determine the length required for each twisted pair. Cut two equal lengths

of wire for each required twisted pair. With the pair of wires side by side,

put one end of each wire in a power drill and spin the wires until there is

approximately one twist per inch of wire. Do not over-twist because this

could damage the wire. Repeat for each required pair.

STEP 6: Layout the Boundary Wire Above Ground

Before burying your boundary wire, we recommend that you run the

complete loop of wire, make all connections and use the receiver collar to

fully test the system with the wire above ground. Referring to the sketch

you made of your system layout, run and connect the wire loop above

ground, connect it to the Transmitter Base Station.

Installation Tip: Leave a little (about 15 inches) slack in the wire

periodically along the perimeter and at the corners of the layout so you

have a little extra wire when needed to repair a break in the loop. Wind

the 15 inch slack into a 5 inch diameter coil and bury it with the wire.

feature and make a map of them.

___________________________________________________________________________________________

High Tech Pet Products, Inc.