Dynasty Fireplaces DY-BTW48 Home Owner's Installation Instructions & Operating Manual - Page 9

Browse online or download pdf Home Owner's Installation Instructions & Operating Manual for Indoor Fireplace Dynasty Fireplaces DY-BTW48. Dynasty Fireplaces DY-BTW48 16 pages.

Print Page

1. Remote Control

Take out the two fixing brackets and 4pcs ST4X10 screws with 4 washers to fix on the left

STEP 3.

and right side panel of the unit. Make sure the distance from the fixing brackets to the fireplace

surface is equal to D in order to make sure the firebox surface is not lower than the plasterboard

surface.

There are two kinds of electrical connections. A. Existing appliance installation. Drag the

STEP 4.

power cord through the hole and plug it into the outlet and push the unit into the recessed wall in

parallel. If an existing grounded outlet is near the appliance, the power cord can run behind the

appliance. If the cord is not long enough to reach the outlet, a grounded extension cord minimum

AWG No. 14 wiring and rated to a minimum or 1875 watts may be used. B. Hard-wire installation.

If it is necessary to hard wire this appliance, a qualified electrician may remove the cord

connection, and wire the appliance directly to the house hold wiring. The appliance must be

electrically connected and grounded in accordance with local codes. 1. Remove the cord

connection. 2. Wire to a properly grounded, 120volt, 60Hz, 15 AMP circuit. 3. Ensure all junction

block connections are tight. 4. Replace the cover and retaining screws.

NOTE! To reduce the risk of fire, do not run the power cord under rugs, carpets, etc.

Arrange the power supply cord away from high traffic areas where it may be pose a

tripping hazard.