High-Flying MYK2011_100 User Manual - Page 15
Browse online or download pdf User Manual for Wireless modules High-Flying MYK2011_100. High-Flying MYK2011_100 17 pages. Low power wi-fi module
Print PageMYK2011_100 Low Power Wi-Fi Module User Manual
3. OEM/INTEGRATORS INSTALLATION
MANUAL
Important Notice to OEM integrators
1.This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to Part 2.1091(b).
3.The separate approval is required for all other operating configurations, including portable configurations
with respect to Part 2.1093 and different antenna configurations
4.For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to verify
compliance as a composite system. When testing the host device for compliance with Part 15 Subpart B,
the host manufacturer is required to show compliance with Part 15 Subpart B while the transmitter
module(s) are installed and operating. The modules should be transmitting and the evaluation should
confirm that the module's intentional emissions are compliant (i.e. fundamental and out of band
emissions). The host manufacturer must verify that there are no additional unintentional emissions other
than what is permitted in Part 15 Subpart B or emissions are complaint with the transmitter(s) rule(s). The
Grantee will provide guidance to the host manufacturer for Part 15 B requirements if needed.
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or co-location
with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not
be used on the final product. In these circumstances, the OEM integrator will be responsible for re-
evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
The final end product must be labeled in a visible area with the following:
Contains
FCC ID: 2ACSVMYK2011-100 ; IC : 12243A-MYK2011100
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user's manual of the end product which integrates this module.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com)
- 15 -