Galileo ADP4000 Installation And Operator's Manual - Page 6

Browse online or download pdf Installation And Operator's Manual for Printer Galileo ADP4000. Galileo ADP4000 8 pages. Ticket printer

Print Page
Cleaning
Using the Cleaning Card
A cleaning card is available for the ADP 4000. This card cleans the print
head and the paper path via a menu selection. To use the cleaning card
follow these instructions:
1. Press ONLINE/ENTER key to take the Unit to Offline/Menu.
2. Press the up or down arrow keys to access MENU PRINT. Press
ONLINE/ENTER key.
3. Press the up or down arrow keys to access PRINT CLEAN. Press
ONLINE/ENTER key.
4. The display will scroll REMOVE ALL STOCK FROM INPUT AND
EXIT BINS.
5. Once the stock has been removed, the display will scroll INSERT
CLEANING CARD IN EITHER BIN.
Follow the instructions on the cleaning card envelope. Do not open the
envelope until you are ready to insert the cleaning card into the printer.
6. Upon inserting the pre-saturated cleaning card, the coupon will move
back and forth three times over the print head and the magnetic
read/write heads while the display scrolls CLEANING IN PROGRESS.
The operator will hear the drive rollers inside the printer spin dry for
about 10 seconds after each pass.
7. The cleaning card will exit the unit when the cleaning cycle is
complete. Properly dispose of the used cleaning card.
Press EXIT/RESET three times to return to Offline/Menu, then
press ONLINE/ENTER to return to Online.
Cleaning card kits are available from Unimark:
700-5014-205K (Qty 5)
700-5014-225K (Qty 25).
Galileo by Travelport obtained written permission from Unimark to reproduce contents of the Sprite Quick Reference Card 71U-1405-500; REV B, © 2006 Unimark Products, LLC. for
the ADP 4000 Quick Reference Card. No part of this publication may be reproduced or transmitted without prior written permission of Galileo by Travelport, or Unimark, Inc.
ADP 4000 Quick Reference Card
External Surfaces Cleaning Procedure
Examine the enclosure's external and internal surfaces,
ventilation slots, transport assembly, and internal components for
dust buildup. All dust should be removed at least every three
months to maintain performance.
1. Vacuum dust accumulation from the ventilation slots and
2. Dampen a soft cloth or paper towel with a mild solution of
3. Dry the cleaned area with a clean, dry cloth or paper towel.
Internal Surfaces Cleaning Procedure
Dust is primarily produced by ticket stock passing through the transport
assembly inside the ADP 4000 enclosure. Clean the internal surfaces of
the enclosure as follows:
1. Toggle the POWER switch to 0 (OFF).
2. Unplug power cord from back of the enclosure.
3. Unlock door on left side of enclosure and open to a maximum of 90
4. Remove all card stock from enclosure by rotating knobs along
5. Use compressed air to blow dust from ticket stock path grooves in
6. Vacuum as much dust as possible from inside enclosure.
ADP 4000 Printer Quick Reference Guide (January 2007)
5
other external surfaces of the ADP 4000.
soap and water or a mild commercial cleaner and wipe the
surface.
CAUTION: To prevent damage, do not force door open beyond 90º.
The enclosure has door locks to limit door opening to 95º.
degrees.
transport path as required.
transport assembly.