Dynatech MP-3000 Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Amplifier Dynatech MP-3000. Dynatech MP-3000 16 pages. Professional power amplifiers mp series

Dynatech MP-3000 Owner's Manual
PROFESSIONAL POWER AMPLIFIERS
10. Fan Outlet Ports
Cooling air enters the amplifier through the front grills and exhausts through the fans. Be sure not to
block these ports when installing the amplifier or other associated equipment. Air must flow unimpeded
through these ports.
11-13.Balanced 1/4" (TRS) & XLR Input Connectors.
These connectors accept input signals on balanced TRS and XLR input plugs.
See the figure at the right for information on polarity. Connectors for each chan-
nel are in parallel; the unused connectors may be used for "loop through" con-
nection to other amplifiers.
NOTE.' Unbalanced "Tip/Sleeve" plugs may be used with the balanced TRS
"Tip/Ring/Sleeve" connectors. The "ring" terminal or negative input will be
connected to ground internally. When using three-pole ('stereo ')TRS connec-
tors, make sure that the ring connection is made either to the cold (-) output of
the source equipment, or to ground. Incorrect connections may cause a 6dB loss
in level.
14-15.SUBWOOF filter frequency and select switch MP-Series 3U model have `SUBWOOF` filter
function, Subwoof switch on `SUBWOOF` position , SUBWOOF is working. You can adjust `SUBWOOF`
filter frequency. Push the switch on `NORMAL` pos-tion,The amplifier works on normal full audio
frequency status without subwoof filter.
NOTE! SUBWOOF FUNCTION IS ONLY FOR 3U MODEL MP-4000/MP-5000/MP-7000
Page 6
MP SERIES
MP-3000 (2U MODEL)
MP-4000 MP-5000 MP-7000 ( 3U MODEL)

Rear Panel

10
POWER AMPLIFIER
FREQUENCY
SUB
WOOF
20Hz
200Hz
2
1
3
NORMAL
18
10
11
12
18
11
16
12
15
14
INPUT
FREQUENCY
BAL.
2
1
SUB
WOOF
STEREO
20Hz
200Hz
BRIDGE
PARALLEL
NORMAL
Serial No.:
19
15
13
16
17 17
GROUND
LIFT
CAUTION:
MINIMUM LOAD IMPEDANCE 2 OHM PER CHANNEL, 4 OHM BRIDGE
19
20
17
PUSH TO RESET
~220VAC 50Hz
1800 WATTS
20
TIP
RING
SLEEVE GROUND ( )
2 3
1
1 3
Rear Panel
POSITIVE (+)
NEGATIVE (-)
2
1. GROUND ( )
2. POSITIVE (+)
3. NEGATIVE (-)