Dynatech BBM Additional Maintenance And Repair Instructions - Page 8
Browse online or download pdf Additional Maintenance And Repair Instructions for Saw Dynatech BBM. Dynatech BBM 10 pages. Mini masonry saw
Print PageBBM & YBM INSTRUCTIONS [May 2004]
Adjusting the Cutting Head Depth
8. Insert the washer with the two alignment holes into
the slot of the upright on the motor side. Insert the
two Phillips head screws and tighten.
the handle will ease tension on the Phillips head screws
while tightening.
9. Push the cutting head to the highest possible raised
position. Squeeze and hold the two uprights "snug"
against the aluminum pivot bar cover tubes and then
tighten the 5mm set screw on the top of the upright
on the motor side.
pivots as far up as possible and make sure to tighten
the 5mm set screw until it screams.
10. Place the blade on the spindle and pivot the head
down as far as possible. If the blade makes contact
with the table, repeat the procedure and make sure
the head remains in the maximum possible raised
position before tightening any of the set screws.
11. Insert the 17mm hex head cap screw, lockwasher,
and washer assembly into the hole in the upright on
the motor side and then tighten the cap screw.
12. Position the torsion spring cover and use a Phillips
head screw driver to tighten the screws that hold
the cover in place.
COMPLETE
NEVER ATTEMPT ANY OF THE INSTRUCTIONS WITH POWER CONNECTED TO SAW!
Lifting up on
Make sure the cutting head