Gallagher T10 Installation Note - Page 4
Browse online or download pdf Installation Note for Card Reader Gallagher T10. Gallagher T10 11 pages. Reader
Also for Gallagher T10: Installation Notes (12 pages), Installation Notes (12 pages)
Print Page
Installation Note | Gallagher T10 Mifare Reader
1.
Using the drill template at the back of this installation note as a
guide, drill all three holes. Drill the 13mm (1/2 inch) diameter centre
hole (this is the centre hole for which the building cable will exit the
mounting surface) and the two fixing holes.
2.
Run the building cabling out through the centre hole and through the
reader base.
3.
Secure the base to the mounting surface using the two fixing screws
provided. It is important the base of the reader is flush with and tight
against the mounting surface.
Note: Ensure the centre hole allows the cable to run freely out through
the mounting surface, so that the reader facia can clip into the base.
4.
Connect the reader tail extending from the facia assembly to the
building cable. Connect the wires shown below.
Note: Do not cut the 'Reserved' wires, they may be required later.
5.
Fit the facia assembly into the base by clipping the small lip, into the
top of the base and holding the top, press the bottom of the facia
assembly down into the base.
4 | Part Number: 3E2453 R1
6 Gauge screw
Building cable
6 Gauge screw
Positive
Negative
Reserved
Reserved
Reserved
CDXIV TX
CDXIV RX
Base
Red
Black
Orange
Green
Brown
White
Blue