Emerson CSB400 Series Installation Sheet - Page 4

Browse online or download pdf Installation Sheet for Industrial Equipment Emerson CSB400 Series. Emerson CSB400 Series 8 pages. Balance port and stem/ stem guide change-out procedure

Print Page

CSB400 Series

Step 7. Remove the old stem and stem guide from actuator by gripping the actuator stem with a pair of pliers and

gently pulling the stem guide until the O-ring seal breaks free. The use of pliers to remove the stem will permanently

damage the stem. Discard the old stem and stem guide immediately; these are never to be reused. Ensure that the

placement of the new stem cap is correct; refer to the picture above.

Step 8. Replace the stem and stem guide with the new set that came pre-lubricated in your kit making sure the

guide ribs on the stem guide are positioned into the grooves of the lower casing correctly. Apply Dow Corning

or comparable extreme low temperature lubricant to the tip of the stem. The O-ring on the stem guide should not

be lubricated.

Dow Corning

is a registered trademark owned by Dow Corning Corporation.

old actuator stem

O-ring seal

position guide ribs into

the grooves correctly

do not lubricate

this O-ring

gently push

gently pull

Stem cap

Stem

new actuator stem

in place

lubricate tip of stem