Emerson ER107001 Owner's Manual - Page 12

Browse online or download pdf Owner's Manual for Accessories Emerson ER107001. Emerson ER107001 15 pages. Wireless 720p hd video doorbell and indoor chime with two-way audio, motion-activated alerts and night vision for ios and android app

Print Page

Trouble Shooting Guide

Error message "Set up

There may be trouble connecting to

failed" or "Initial failed,

the server. Please check firewall

Please check whether

settings or try another network.

the current network is

available" appears

Doorbell rings but no

1. Make sure the device password is

notifications

correct. Please refer to point 2.1 of

Section 7 to modify if necessary.

2. Make sure the Wifi password

entered during setup is correct. If

you are not sure, please delete the

device from the list and setup again

(Point 2.1 of section 7).

3. If you do not receive notifications

but can answer and enter the

intercom interface, please check if

you allowed notifications for this

App. Please go to phone's settings

and select this App to check.

4. Please check if Push Notifications

is ON (Point 2 of section 7).

When the "Answer" icon

On standby mode without doorbell

rings or after motion is detected, you

is in gray, cannot enter

cannot enter the intercom interface.

the intercom interface.

After doorbell rings or motion detected

Tap the blue "Answer"

for a period of time, the device will

icon to enter the

return to standby mode again. There

interface but cannot see

may be a short period of delay for the

anything.

blue icon turns to gray.

Somebody is in front of

1. Please make sure "Push

Notifications", "PIR" and "Push-PIR"

the doorbell but there is

are ON (Section 7).

no notification.

2. Please check if you allowed

notifications for this App. Please go

to phone's settings and select this

App to check.

Reset to factory settings Power on the doorbell. Press the

Call Button (doorbell ring will sound).

Then press and hold the Reset

button for about 5 seconds until the

doorbell ring stops.

-21-

13. FCC Statement and Safety Warnings

FCC STATEMENT:

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received,

including interference that may cause undesired

operation.

WARNING: Changes or modifications not expressly approved

by the party responsible for compliance could void

the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures: reorient or relocate the receiving antenna,

increase the separation between the equipment and receiver,

connect the equipment into an outlet on a circuit different from

that to which the receiver is connected, consult the dealer or an

experienced radio/TV technician for help.

RF WARNING STATEMENT:

Installation of this device must not be readily accessible to

human subjects closer than 20 cm (8").

PRODUCT USE AND PROTECTION:

Read and follow all instructions. Use only as intended.

These device is intended to be used indoors only. It is not

-22-