adeptus 88040 Assembly Instructions Manual - Page 4

Browse online or download pdf Assembly Instructions Manual for Outdoor Cart adeptus 88040. adeptus 88040 10 pages. 4 + 1 drawer euro roll cart

Print Page

PREPARE PARTS FOR ASSEMBLY

THIS STEP REQUIRES A FLAT, HARD SURFACE,

NOT A BED!

PUSH THE DOWELS (PART A) INTO THE EDGES

OF THE FOLLOWING PARTS, AS SHOWN:

(PART 2) RIGHT SIDE

(PART 3) LEFT SIDE

(PART 5) FRONT CASTER SUPPORT

(PART 6) BACK CASTER SUPPORT

• ATTACHING DRAWER RUNNERS:

THE DRAWER RUNNERS (PART B) WILL STRETCH

SLIGHTLY AS YOU HAMMER THEM INTO PLACE.

• LINE UP THE PIPS IN DRAWER RUNNERS (PART B)

TO THE PRE-DRILLED HOLES IN THE RIGHT SIDE

PANEL (PART 2).

• EASE THE PIPS INTO THE HOLES BY TAPPING EACH

PIP DOWN HALF WAY. START ON ONE END, THEN

THE MIDDLE, THEN THE OTHER END.

• WHEN ALL 3 PIPS ARE HALF WAY DOWN AND THE

DRAWER RUNNER (PART B) IS STRETCHED,

HAMMER THE RUNNER ALL THE WAY DOWN UNTIL

IT IS FLUSH WITH THE RIGHT SIDE

PANEL (PART 2).

• REPEAT THESE STEPS TO ATTACH THE

DRAWER RUNNERS (PART B) TO THE

LEFT SIDE (PART 3).

TIP: Using a regular

hammer to attach the

runners provides a

clearer line of sight than

a rubber mallet.

NEXT PREPARE CASTER SUPPORTS:

• USE A HAMMER OR RUBBER MALLET TO INSERT

CASTER INSERT (PART Eb) INTO THE BOTTOM OF

THE FRONT CASTER SUPPORT (PART 5) AND

BACK CASTER SUPPORT (PART 6).

• TAP ABOVE THE BACK OF THE CASTER (ABOVE

THE STEM) TO ASSEMBLE CASTERS (PART Ea)

INTO THE CASTER INSERT (PART Eb).

A=12

B=10

Dowel

Drawer

8.0 x 30mm

Runner

Ea=04

Eb=04

Caster and Insert

NOTICE: THE WRITTEN INSTRUCTIONS CONTAINED HEREIN COPYRIGHTED.

3rd

2nd

1st

making assembly difficult and could

lead to damage of the parts.

bounce

4-10