GALLUNOPTIMAL 4250078326090 Operating Instructions
Browse online or download pdf Operating Instructions for Power Tool GALLUNOPTIMAL 4250078326090. GALLUNOPTIMAL 4250078326090 2 pages.
Print PageGALLUNOPTIMAL
THANK YOU FOR PURCHASING A GALLUNOPTIMAL SOLDERING IRON. Please read the operating instructions
before operating and keep them in a safe place easily accessible to all users.
Before leaving the factory, the soldering iron is subjected to a test. This results in the soldering tip being covered
with solder and may be slightly discolored. This does not represent a defect.
Failure to observe the following instructions may result in serious injury or death to the user.
If the device is switched on, the soldering tip automatically heats up to the last set temperature.
There is a risk of burns on the metallic surfaces!
The device is designed for soldering soft solder at different temperatures. Any other use is not permitted.
Do not touch the metallic parts on the tools during operation and immediately after switching off, CAUTION! Risk
of burns!
Do not use the device in the vicinity of flammable substances and components.
Use a heat-resistant work surface and keep your workplace clean.
Solders, fluxes and heated materials can develop harmful properties and should be exhausted in a controlled
manner. Do not inhale these toxic fumes or gases and provide adequate ventilation.
The device may only be used in dry rooms. Protect the device from liquids and moisture. Do not touch the device
with wet hands. Otherwise, short circuits and electric shocks could be triggered.
Inform other persons in the working area that the temperature can be very high during operation. Switch off the
device as soon as the work is finished to avoid danger.
Do not leave the device unattended while it is switched on.
After switching off, wait until the heated parts have reached room temperature if you want to touch or change
parts on them.
Features :
Soldering iron with precise temperature control
Rapid cartridge soldering tip system
Ergonomic handle
Temperature adjustable via rotary control on the
soldering iron
Calibration function
Change the cartridge soldering tip: Important NOTE!
Switch off the device to change the cartridge soldering tip! Let the soldering tip cool down to room
temperature to prevent burns! Push back the handle pad (silicone cover) on the soldering iron and loosen
the grub screw for fixing the soldering tip. Use an optionally available silicone pad for optimum extraction
and protection from any residual heat. Only original GALLUNOPTIMAL replacement cartridges for
SPRINT80+ & 80D+ may be used and inserted into the handle! Then lightly tighten the screw again to
secure the cartridge soldering tip! Never change a soldering tip with the grub screw tightened,
otherwise the cartridge tip may be damaged when pulled out!
Switch on: Press the slide switch, the LED starts flashing very fast and signals the heating up to the
setpoint. Slow flashing means that the SET temperature has been reached. If the LED does not light up,
the soldering tip temperature is higher than the SET temperature.
Soldering Iron
WARNING
SPRINT80+
Technical Data:
Input Voltage 230VAC
Power 80W
Temp. range 200-500°C
Temp. stability +/- 2°C
Temp. unit °C
Impedance tip-ground <0,1 Ω
Voltage tip-to-ground <2mV
Connection cable 1,28m
Weight 160g