HighTek Harness Group HTKWLAN02 User Manual - Page 16

Browse online or download pdf User Manual for Network Card HighTek Harness Group HTKWLAN02. HighTek Harness Group HTKWLAN02 17 pages. 11mbps minipci wlan card

Print Page

the event the users places the device in their lap during use (i.e. positioning of antennas must be

placed in the upper portion of the LCD panel only to ensure 20 cm will be maintained if the user

places the device in their lap for use) and

2) The transmitter module may not be co-located with any other transmitter or antenna.

As long as the 2 conditions above are met, further transmitter testing will not be required. However,

the OEM integrator is still responsible for testing their end-product for any additional compliance

requirements required with this module installed (for example, digital device emissions, PC

peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop

configurations or co-location with another transmitter), then the FCC authorization is no longer

considered valid and the FCC ID can not be used on the final product. In these circumstances, the

OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and

obtaining a separate FCC authorization.

This transmitter module is authorized only for use in devices where the antenna may be installed

such that 20 cm may be maintained between the antenna and users (for example access points,

routers, wireless ASDL modems, certain laptop configurations, and similar equipment). The

final end product must be labeled in a visible area with the following: "Contains TX FCC ID:

{Q2EWLAN02 }".

RF Exposure Manual Information That Must be Included

The users manual for end users must include the following information in a prominent location

"IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used

for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons

and must not be co-located or operating in conjunction with any other antenna or transmitter."

Additional Information That Must be Provided to OEM Integrators

The end user should NOT be provided any instructions on how to remove or install the device.

End Product Labeling